Table of Contents
Advertisement
HD2 IP55 High-ingress Protection Series
Function
code
High-frequency
superposition
P13.06
P13.07
P13.08
parameter 1
P13.09
parameter 2
P13.10
Maladjustment
P13.11
detection time
High-frequency
compensation
P13.12
coefficient of
synchronous
High-frequency
P13.13
injection current
P13.19
Function
code
communication
P14.00
Communication
P14.01
baud rate setup
Name
frequency
(reserved)
0.0–300.0% rated motor voltage
voltage
Reserved
/
Control
0–0xFFFF
Control
0–655.35
Reserved
/
This parameter is used to adjust the
responsiveness
function. If the load inertia is large, increase the
value of this parameter properly, however, the
responsiveness may slow down accordingly.
Setting range: 0.0–10.0s
This parameter is valid when the motor speed
exceeds the rated speed. If motor oscillation
occurred, adjust this parameter properly.
Setting range: 0.0–100.0%
motor
0–300.0% (of the rated inverter output current) 20.0%
Reserved
/
P14 group––Serial communication function
Name
Setting range: 1–247
When the master is writing frames, and the
slave communication address is set to 0, it is
the broadcast communication address, and all
Local
the slaves on the Modbus bus will accept this
frame, but the slave never responds.
address
Local communication address is unique in the
communication network, which is the basis for
point-to-point communication between the
upper computer and the inverter.
Note: The slave address cannot be set to 0.
This parameter is used to set the data
transmission speed between upper computer
and the inverter.
0: 1200BPS
Description
of
anti-maladjustment
Description
-183-
Function parameter list
Default
Modify
value
◎
100.0%
/
/
○
0
○
2.00
/
/
○
0.5s
○
0.0
◎
/
/
Default
Modify
value
○
1
○
4
Advertisement
Table of Contents
