Digital Input - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series
Function
code
Corresponding HDO output
P06.28
P06.29
Corresponding HDO output
P06.30
P06.31

5.5.11 Digital input

The HD2IP series inverter carries four programmable digital input terminals and two HDI input
terminals. The function of all the digital input terminals can be programmed by function codes.
HDI input terminal can be set to act as high-speed pulse input terminal or common digital input
terminal; if it is set to act as high-speed pulse input terminal, users can also set HDIA or HDIB
high-speed pulse input to serve as the frequency reference and encoder signal input.
P05.08 (input terminal polarity)
This parameter is used to set the corresponding function of digital multi-function input
terminals.
Note: Two different multi-function input terminals cannot be set to the same function.
Set
value
0
1 Forward running (FWD)
2 Reverse running (REV)
3
4
5
6
Name
of lower limit
Upper limit of HDO output P06.27–300.0%
of upper limit
HDO output filter time
P05.09 (digital filter time)
P05.12
T delay
P05.14
T delay
P05.16
T delay
P05.18
T delay
P05.20
T delay
P05.22
T delay
Function
No function
3-wire control
Forward jogging
Reverse jogging
Coast to stop
Description
0.00–50.00kHz
0.00–50.00kHz
0.000s–10.000s
Digital function selection
P05.13
P05.15
P05.17
P05.19
P05.21
P05.23
The inverter does not act even if there is signal input;
users can set the unused terminals to "no function" to
avoid misacts.
Control the forward/reverse running of the inverter by
external terminals.
Set the inverter running mode to the 3-wire control
mode by this terminal. See P05.13 for details.
Frequency when jogging, see P08.06, P08.07 and
P08.08 for jogging acceleration/deceleration time.
The inverter blocks output, and the stop process of
motor is uncontrolled by the inverter. This mode is
applied in
-83-
Basic Operation Instructions
Description
Default
value
0.0kHz
100.0%
50.00kHz
0.000s
Run