Structure Diagram - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series inverter
Note:
1. The input current of HD2IP-9.5A-43 to HD2IP-75A-43 inverters are measured in cases
where the input voltage is 380V without additional reactors;
2. The rated output current is the output current when the output voltage is 380V;
3. Within allowable input voltage range, the output current/power cannot exceed rated output
current/power.

3.7 Structure diagram

The inverter layout is shown in the figure below (HD2IP-32A-43 inverter as an example).
No.
1
2
3
4
5 Baffle of control board
6
7
8
9 Main circuit terminal
10 Control terminals
11 Waterproof connector
12 POWER indicator
13
14
15
Figure 3-5 Structure diagram
3
Name
Upper cover
Keypad
Lower cover
Extension card
Cooling fan
Keypad interface
Nameplate
Label of HD2IP
product series
Baffle of fan
Switch handle
Protect internal components and parts
For details, see section 5.4 "Keypad operation"
Protect internal components and parts
Optional part. For details, see Appendix A "Extension
cards"
Protect the control board and install extension card
For details, see 8 "Routine maintenance"
Connect the keypad
For details, see 3 "Product Overview"
For details, see 4 "Installation Guide"
For details, see 4 "Installation Guide"
Lock and secure connection cables
Power indicator
For details, see section 3.5 "Product model" of this
chapter
Protect the fan.
Control the main circuit power.
-12-
Product Overview
Instruction