Dimensions And Installation - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series Inverter
Resolver PG card
HD2-E-PGR
A.2 Dimensions and installation
All extension cards are of the same dimensions (108 mm × 39 mm) and can be installed in the
same way.
Following the following operation principles when installing or removing an extension card:
1. Ensure that no power is applied before installing the extension card.
2. The extension card can be installed in any one of the SLOT1, SLOT2, and SLOT3 card slots.
3. inverters of HD2IP-9.5A-43 or below can be configured with two extension cards, inverters
of HD2IP-18.5A-43 or higher can be configured with three extension cards.
4. If interference occurs on the external wires after extension cards are installed, change their
installation card slots flexibly to facilitate the wiring. For example, the connector of the
connection cable of the Profibus DP card is large, so it is recommended to be installed in the
SLOT1 card slot.
Figure A-1 shows the installation diagram and an inverter with extension cards installed.
Figure A-1 inverter of HD2IP-18.5A-43 or higher with extension cards installed
Multi-function
incremental PG card
HD2-E-PGIM
EC1
EC installation diagram
Diagram of ECs installed
-292