Advertisement
5-2 Function Explanation
F13
Electronic thermal O/L relay
(for braking-resistor)
Inverter capacity
Operation
VXM750 or lower
0 : Inactive
1 : Active (built-in braking-resistor)
2 : Active (external braking-resistor)
VXM1100 or greater 0 : Inactive
If value "2" is selected, set up the type of
braking resistor, and a connection circuit by
function code:U59.
Please refer to U59 for
details.
F14
Restart mode after momentary
power failure (operation selection)
If selecting value "2" or "3", both integration
constant and the proportional constant during
operation ride-though can be adjusted by the
function code:U23 and U24.
Please refer to function
codes:U23 and U24 for
details.
F25
Stop Frequency
Set values: 0.1 to 60.0Hz
F41
Torque limit 1 (braking)
E17
Torque limit 2 (braking)
The upper limit of frequency increase at the
torque limit operation is set by the function
code: U01.
When the set value "0%(Regeneration
avoidance)" is set, the operation mode is set
by the function code:U60.
Please refer to the
function code:U01 and
U60 for details.
5 Function Selection
Set
value
Line speed control cancellation [Hz/LSC
Line speed frequency memory [LSC-HLD]
Related Functions
U59
Frequency setting 1/Frequency setting 2 [Hz1/Hz2]
Related Functions
U23
input signal
U24
note: This set value cannot be used with the set
value "11" simultaneously. When the set value
"11" and "35" are selected, the display becomes
"Er6".
Set
value
Related Functions
U01
U60
Life expectancy detection signal [LIFE]
117
E01
X1 Terminal function
E09
X9 Terminal function
Function
33
Line speed control cancellation [Hz/LSC
34
Line speed frequency memory [LSC-HLD]
35
Frequency setting 1/ Frequency setting 2
[Hz1/Hz2]
These functions are effective for the option
card (VXMEFC/OPC-G11S-PG, PG2, -PGA).
Refer to each option manual.
This function switches the frequency setting
method set in function codes F01 and C30 by
an external digital input signal. It is reverse-
logic of the set value "11" (frequency set
2/frequency set 1[Hz2/Hz1]).
Set value
Frequency setting method selected
35
Off
C30 FREQ CMD2
On
F01 FREQ CMD1
E20
Y1 Terminal function
E24
Y5A and Y5C Terminal function
Function
30
Life expectancy detection signal [LIFE]
35
Speed agreement signal [DSAG]
36
PG error signal [PG-ABN]
37
Torque limiting (Signal with delay [TL2]
When a component's 'Life expectancy' time is
reached, an ON signal can be output.
However, the inverter does not go into alarm
and the fault relay does not change state.
]
]
5-65
Advertisement
