Parameter Backup; System Setup - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series Inverters
16:02:35
Forward Local Ready
Common parameter setup
Parameter setup
State monitoring/fault record
Motor parameter autotuning
Parameter backup/restore to default value
System setting
Return Homepage
After selecting motor autotuning type, enter motor parameter autotuning interface, and press
RUN key to start motor parameter autotuning. After autotuning is done, a prompt will pop out
indicating autotuning is succeeded, and then it will return to the main interface of stop. During
autotuning, users can press
autotuning, the keypad will pop out a fault interface.
16:02:35

5.4.9 Parameter backup

In "parameter backup" menu, press
parameter backup setting interface and function parameter restoration setup interface to
upload/download inverter parameters, or restore inverter parameters to default value. The
keypad has three different storage areas for parameter backup, and each storage area can
save the parameters of one inverter, namely it can save parameters of three inverter in total.
16:02:35
Forward Local Ready
Common parameter setup
Parameter setup
State monitoring/fault record
Motor parameter autotuning
Parameter backup/restore to default value
System setting
Return Homepage

5.4.10 System setup

In "System setup" menu, press
interface to set keypad language, time/date, backlight brightness, backlight time and restore
parameters.
Note: Clock battery is not included, and the keypad time/date needs to be reset after power off.
If timekeeping after power off is needed, users should purchase the clock batteries separately.
Figure 5-18 Parameter autotuning operation diagram
16:02:35
Ensure motor nameplate parameters are set
correctly!
Return
Select
STOP/RST
Figure 5-19 Parameter autotuning finished
Forward Local Run
Figure 5-20 Parameter backup operation diagram
Select
Forward Local Ready 01: HD2IP
Add
Confirm
key to terminate auto tuning; if any fault occur during
16:02:35
Forward
key,
key, key or
-43-
Basic Operation Instructions
16:02:35
Forward
Complete parameter rotary autotuning
Complete parameter static autotuning
Partial parameter static autotuning
Return
Local Run
key or key to enter function
16:02:35 Forward Local
Upload local function parameters to keypad
Download complete keypad function parameters
Download keypad function parameters not in motor
group
Download keypad function parameters in motor group
Return Homepage
key to enter system setup
Local Ready 01: HD2IP
Homepage
Confirm
Ready 01: HD2IP
Select