Motor Parameter - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series
Function
code
Keypad limit value of
upper limit frequency
P03.16
of forward rotation in
Keypad limit value of
upper limit frequency
P03.17
of reverse rotation in
Source of upper limit
P03.18
Source of upper limit
P03.19
setup of brake torque
Set upper limit of the
P03.20
motoring via keypad
P03.21
P17.09 Motor output torque -250.0–250.0%
P17.15

5.5.6 Motor parameter




Name
torque control
torque control
setup of the torque
during motoring
torque when
Set upper limit of
brake torque via
keypad
Torque reference
value
Check the safety conditions surrounding the motor and load machineries before
autotuning as physical injury may occur due to sudden start of motor during
autotuning.
Although the motor does not run during static autotuning, the motor is stilled
supplied with power, do not touch the motor during autotuning; otherwise,
electric shock may occur.
If the motor has been connected to load, do not carry out rotary autotuning;
otherwise, misact or damage may occur to the inverter. If rotary autotuning is
carried out on a motor which has been connected to load, wrong motor
parameters and motor misacts may occur. Disconnect the load to carry out
autotuning if necessary.
Description
0.00Hz–P00.03 (max. output frequency)
0.00Hz–P00.03 (max. output frequency)
0: Keypad (P03.20)
1: AI1
2: AI2
3: AI3
4: Pulse frequency HDIA
5: Modbus communication
6: PROFIBUS/CANopen/DeviceNet
communication
7: Ethernet communication
8: Pulse frequency HDIB
9: EtherCAT/PROFINET communication
10: PLC
11: Reserved
Note: For setting sources 1–4 and 8, 100%
corresponds to three times the rated motor
current.
0: Keypad (P03.21)
1–10: the same as P03.18
0.0–300.0% (rated motor current)
0.0–300.0% (rated motor current)
-300.0–300.0% (rated motor current)
-62-
Basic Operation Instructions
Default
value
50.00 Hz
50.00 Hz
180.0%
180.0%
0.0%
0.0%
0
0