P11 Group--Protection Parameters - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series
PLC restart
P10.36
Multi-step
P10.37
P11 group––Protection parameters
Function
code
Phase-loss
P11.00
protection
Frequency-
P11.01
power down
P11.02 braking for
Overvoltage
P11.03
protection
0: Restart from the first step, namely if the
inverter stops during running (caused by stop
mode
command,
fault or power down), it will run from the first step
after restart.
1: Continue running from the step frequency
when interruption occurred, namely if the inverter
stops during running (caused by stop command
or fault), it will record the running time of current
step, and enters this step automatically after
restart, then continue running at the frequency
defined by this step in the remaining
time
0: s; the running time of each step is counted in
seconds;
time unit 1: min; the running time of each step is counted
in minutes;
Name
0x000–0x111
Ones:
0: Disable software input phase loss protection
1: Enable software input phase loss protection
Tens:
0: Disable output phase loss protection
1: Enable output phase loss protection
Hundreds:
0: Disable hardware input phase loss protection
1: Enable hardware input phase loss protection
0: Disable
drop at
transient 1: Enable
Energy
0: Enable
1: Disable
stop
0: Disable
1: Enable
stall
Description
-173-
Function parameter list
◎
0
◎
0
Default
Modify
value
○
0x110
○
0
◎
0
○
1