Add Parameters To The Parameter List Displayed In Stop/Running State - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series Inverters
Press
key or
(parameter list), the returned list is the list edited. If
interface without selecting edit operation, it will return to the previous menu (parameter list
remain unchanged).
Note: For the parameter objects in the list header, shift-up operation will be invalid, and the
same principle can be applied to the parameter objects in the list footer; after deleting a certain
parameter, the parameter objects under it will be shifted up automatically.
The monitoring items displayed in the parameter list of running state can be added by users as
needed (through the menu of the function code in state check group), and the list can also be
edited by users eg "shift up", "shift down" and "delete from the list". The edit function is shown
in the interface below.
The parameter list of common parameter setup can be added, deleted or adjusted by users as
needed, including delete, shift-up and shift-down; the addition function can be set in a certain
function code of a function group. The edit function is shown in the figure below.
16:02:35
Forward Local Ready
Common parameter
setup
Parameter setup
State monitoring/fault
record
Motor parameter
autotuning
Parameter backup/restore
to default value
System setting
Return Homepage

5.4.3 Add parameters to the parameter list displayed in stop/running state

In the fourth-level menu of "State monitoring", the parameters in the list can be added to the
"parameter displayed in stop state" list or "parameter displayed in running state" list as shown
below.
Figure 5-10 List edit diagram 1
16:02:35
P17.00：Set frequency
P17.11：DC bus voltage P17.12：
Digital input terminal state P17.13：
Digital output terminal state P17.23：
PID reference value
P17.24：PID feedback value
Return
key to enter edit interface, select the operation needed, and press
key to confirm the edit operation and return to the previous menu
Figure 5-11 List edit diagram 2
16:02:35
P17.01：Output frequency
P17.00：Set frequency
P17.11：DC bus voltage
P17.03：Output voltage
P17.04：Output current
P17.05：Motor speed
Return
Figure 5-12 List edit diagram 3
16:02:35
01: HD2IP
P00.10：Keypad setting frequency
P00.00：Speed control mode
P00.11：Acceleration time 1
P00.12：Deceleration time 1
P00.01：Running command channel P00.13：
Running direction selection
Select Return
Forward 01: HD2IP
Local Ready
Edit
Confirm
Forward Local Ready 01: HD2IP
Edit
Confirm
Forward
Local Ready 01: HD2IP
Edit Select
-39-
Basic Operation Instructions
16:02:35 Forward
Local
Shift up
Shift down
Delete from the list
Return Homepage
key or key is pressed in edit
16:02:35 Forward Local
Shift up
Shift down
Delete from the list
Return Homepage
16:02:35 Forward
Local
Shift up
Shift down
Delete from the list
Return Homepage
Ready 01: HD2IP
Select
key,
Ready 01: HD2IP
Select
Ready 01: HD2IP
Select