Advertisement
Quick Links
Advertisement
Related Manuals for IMO Jaguar VXM
Summary of Contents for IMO Jaguar VXM
- Page 1 Instruction manual IMO Jaguar VXM General Purpose Inverter Three-phase 400V 0.4 - 400kW...
- Page 3 12.1...
- Page 120 The following functions are changed or added, refer to section 5-1 Function No. NAME Change of added contents Electric thermal O/L relay (for braking-resistor) "External braking resistor" of set value 2 means the resistor of type "DB***-2C/4C". Restart mode after momentary power failure(operation selection) In case of set value 2 or 3, setting of U23, U24 becomes effective.
-
Page 121: Function Explanation
5-2 Function Explanation X1 Terminal function X9 Terminal function Electronic thermal O/L relay (for braking-resistor) Function value Inverter capacity Operation Line speed control cancellation [Hz/LSC VXM750 or lower 0 : Inactive Line speed frequency memory [LSC-HLD] 1 : Active (built-in braking-resistor) Frequency setting 1/ Frequency setting 2 2 : Active (external braking-resistor) [Hz1/Hz2]... - Page 122 ACC/DEC pattern (mode select) Function Parts of Life Life expectancy code expectancy judgment judgment level Capacitor in main 85% or less of the This function selects the acceleration and circuit initial value deceleration pattern. Electrolytic capacitor Set value 61,000 hours on PC board 0 : Inactive (linear...
- Page 123 U functions are displayed from keypad ROM version K08000 or later Maximum compensation frequency during braking torque limit This function becomes effective, when the torque limit (braking) is used. The inverter automatically increases the output frequency so that torque calculations do not exceed the braking torque limit setting ( F41 or E17).
- Page 124 Turn off the power supply of inverter, until the U08 Initial value of main DC link capacitor inverter and the cooling fan have stopped. It U09 Measured value of main DC link capacitor is not necessary to remove an option card or control terminal connections.
- Page 125 U11 Cooling Fan operating time Filter time constant [ms] “U15” set value The integrated operating hours of the cooling Note: Response time is faster when the set fan are displayed. Since the integrated hours value is bigger. Therefore, there is a possibility are counted by unit hours, power input for that the output frequency may become unstable.
- Page 126 The resistor data above is for 400V VXM series only. Do not connect a resistor of too low [Ω] value. Separate instruction manual is available Failure may result. detailing communication protocol, etc. Contact IMO for details. 5-70 5 Function Selection...
- Page 127 Setting of unit’s digit (connection circuit U60 Regeneration avoidance at declaration selection) This function is available, when torque limit **1) Power Breaking-resistor (brake) of F41( or E17) is set to "0%". Total Duty consumption per resistance cycle resistance Number [Ω] U 6 0 U S E R Connection circuit...
- Page 128 Set the function code in the following procedure. If the inverter is operated without this adjustment after replacing the PCB, normal operation may not be possible. (Offset adjustment) 1) Confirm that the main power supply is turned ON, the motor is connected and is not running (inverter FWD / REV operation command is OFF).
- Page 129 IMO Jaguar VXM series - Software Version UP Identification of products as “Previous software version” and “New software version”. Products up to 22kW Letter “A” is added in the end of serial number of New software version. Products 30kW and larger Please identify with production month seen in the serial numbers.
- Page 149 9 Specifications...
- Page 150 (2) Three-Phase 200V series Nominal applied motor [kw] Type: VXM…A-2 kVARated output capacity (*1) [Kva] Rated output current (*2) [A] 150% of rated current for 1 min 110% of output rated current Overload capability 200% of rated current for 0.5s for 1min 200% or more (under torque Starting torque...
- Page 151 9 Specifications...
- Page 152 9 Specifications...
- Page 153 9 Specifications...
- Page 154 VXM150-VXM400/VXM8A-2-VXM11A-2 VXM40-VXM75 VXM550-VXM750/VXM29A-2 VXM1100-VXM2200/VXM55A-2, VXM78A-2 9 Specifications...
- Page 155 G Dimensions (30kW-220kW) 9 Specifications...
- Page 156 G Dimensions (280kW-400kW) ø C 3 or 4 4 (ø 35) W3 W4 W3 W4 W3 W4 W3 W4 6 or 8 6 or 8 7 or 8 Mounting Mounting Mounting bolts bolts bolts 4 (ø C) Dimension [mm] Inverter Type VXM280K VXM315K 1400...
- Page 157 9 Specifications...
-
Page 161: Electromagnetic Compatibility (Emc)
Commission Guidelines instruction manual Carrier freq. ≤ 4kHz Document on Council Directive 89/336/EEC, IMO has chosen to classify the Jaguar VXM 10m screened motor cable range of Inverters as “Complex Components. maximum Classification as a “Complex Components” Carrier freq. ≤ 4kHz allows a product to be treated as an “apparatus”, and thus permits compliance with... - Page 162 If the DC reactor is not fitted, the supply authority must be consulted and permission to connect to the public low voltage power supply must be obtained prior to installation. For details of harmonic current and reactors, contact IMO Precision Controls Ltd. 11-2...
- Page 163 RFI filter Nominal Weight Applied Rated leakage Rated Mount Dimms Filter Inverter Current (max. Dimensions Voltage Y x X Note Type leakage) LxWxH [mm] [mm] 0.75 1.45 14.0 16.0 42.0 11 Electromagnetic compatibility (EMC) 11-3...
- Page 164 11-4 11 Electromagnetic compatibility (EMC)
- Page 165 11 Electromagnetic compatibility (EMC) 11-5...
- Page 166 12-1...
- Page 168 IMO Precision Controls Limited Out-of-hours telephone contacts 1000 North Circular Road Product Support (UK South) Staples Corner, London NW2 7JP 07831 207220 Telephone: +44 (0)20 8452 6444 Product Support (UK North) Fax: +44(0)20 8452 3512 07836 259108 Product Support (UK Central) Web: www.imopc.com...