Input/Output Signal Connection Diagram - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series inverter

4.4.2 Input/output signal connection diagram

Set NPN /PNP mode and internal/external power via U-type short-contact tag. NPN internal
mode is adopted by default.
If input signal comes from NPN transistors, set the U-type short-contact tag between +24V and
PW based on the power used according to the figure below.
Internal power（NPN mode）
If input signal comes from PNP transistor, set the U-type short-contact tag based on the power
used according to the figure below.
Figure 4-16 Position of U-type short-contact tag
Figure 4-17 NPN mode
External power（NPN mode）
-27-
Installation Guide