Table of Contents
Advertisement
HD2 IP55 High-ingress Protection Series inverter
4.2.3 Installation mode
The inverters can be installed in two modes, depending on the different inverter
(1) Mark the position of the installation hole. See Appendix C "Dimension drawings" for the
position of installation hole;
(2) Mount the screws or bolts onto the designated position;
(3) Put the inverter on the wall;
(4) Tighten the fixing screws on the wall.
Note: Flange-mounting plate is a must for inverters that adopt flange-mounting mode.
4.2.4 Single-unit installation
A
A
Note: The min. dimension of B and C is 100mm.
dimensions: Figure 4-2 Installation mode
Wall-mounting
Figure 4-3 Single-unit installation
B
B
Flange-mounting
-15-
Installation Guide
Advertisement
Table of Contents
