P03 Group--Vector Control Of Motor 1 - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series Inverter
Function
code
coefficient of
Power display
P02.28
coefficient of
P02.29 display of motor
System inertia
P02.30
P02.31–
P02.32
P03 group––Vector control of motor 1
Function
code
P03.00 proportional gain
Name
current, K is motor overload protection
motor 1 coefficient.
The smaller the K, the larger the value of M,
and the easier the protection.
When M=116%, protection is performed after
motor overload lasts for 1 hour; when
M=150%, protection is performed after motor
overload lasts for 12 minutes; when M=180%,
protection is performed after motor overload
lasts for 5 minutes; when M=200%, protection
is performed after motor overload lasts for 60
seconds; and when M≥400%, protection is
performed immediately.
Setting range: 20.0%–120.0%
This function adjusts the power display value
calibration of motor 1 only, and it does not affect the
control performance of the inverter.
motor 1 Setting range: 0.00–3.00
0: Display as per motor type; under this mode,
Parameter
only parameters related to current motor type
will be displayed.
1 1: Display all; under this mode, all the motor
parameters will be displayed.
0–30.000kgm2
of motor 1
Reserved /
Name
Speed loop Parameters of
control mode only. Below P03.02, speed loop
1 PI parameter is
Description
Description
P03.00–P03.05 fit for vector
P03.00 and P03.01; above
-128
Default
Modify
value
○
1.00
○
0
○
0
/
/
Default
Modify
value
○
20.0