Basic Operation Instructions; Keypad Introduction - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series Inverters
5.1 What this chapter contains
This chapter tells users how to use the inverter keypad and the commissioning procedures
for common functions of the inverter.

5.2 Keypad introduction

LCD keypad is included in the standard configuration of HD2IP series inverters. Users can
control the inverter start/stop, read state data and set parameters via keypad.
Note:
1. LCD keypad is armed with real-time clock, which can run properly after power off when
installed with batteries. The clock battery (type: CR2032) should be purchased by the user
separately.
2. LCD keypad support parameter-copy.
No. Name
State
1
Indicator

5 Basic Operation Instructions

Figure 5-1 Keypad diagram
(1) RUN
2) TRIP
(3) QUICK/JOG
Instruction
Running indicator;
LED off – the inverter is stopped;
LED blinking – the inverter is in
parameter
autotune
LED on – the inverter is running
Fault indicator;
LED on – in fault state
LED off – in normal state
LED blinking – in pre-alarm state
Short-cut key indicator, which displays
different state under different functions,
see definition of QUICK/JOG key for
details
-29-
Basic Operation Instructions