Add Parameter To Common Parameter Setup List - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series Inverters
16:02:35 Forwar F orwar F orward d d
Loca L oca L ocal l l
P17.00 P 17.00 P 17.
P17.01 P 17.01 P 17.01： 输
出 频率 ： 输出频率 ： 输出频
率P17.02 P 17.02 P 17.02
：斜坡给定频率 ： 斜坡给
定频率 ： 斜坡给定频率
P17.03 P 17.03 P 17.03：
Press
not included in the "parameter displayed in stop state" list or "parameter displayed in running
state" list, the parameter added will be at the end of the list; if the parameter is already in the
"parameter displayed in stop state" list or "parameter displayed in running state" list, the addition
operation will be invalid. If
operation in "Addition" interface, it will return to monitoring parameter list menu.
Part of the monitoring parameters in P07 HMI group can be added to the "parameter displayed
in stop state" list or "parameter displayed in running state" list; All the parameters in P17, P18
and P19 group can be added to the "parameter displayed in stop state" list or "parameter
displayed in running state" list.
Up to 16 monitoring parameters can be added to the "parameter displayed in stop state" list;
and up to 32 monitoring parameters can be added to the "parameter displayed in running state"
list.

5.4.4 Add parameter to common parameter setup list

In fourth-level menu of "parameter setup" menu, the parameter in the list can be added to the
"common parameter setup" list as shown below.
16:02:35 Forward
P01.00：Running mode of start
P01.01：Starting frequency of direct start
P01.02：Hold-up time of starting frequency
P01.03：Brake current before start P01.04
：Brake time before start
P01.05：Acceleration/deceleration mode selection
Return
Press
confirm the addition operation. If this parameter is not included in the original "common
parameter setup" list, the newly added parameter will be at the end of the list; if this parameter
is already in the "common parameter setup" list, the addition operation will be invalid. If
Figure 5-13 Add parameter diagram 1
16:02:35
H D 2 I P H D 2 I P H D 2 I P
返回 返 回 返 回
key to enter parameter addition interface, select the operation needed, and press
key, key or
Figure 5-14 Add parameter diagram 2
Local Ready 01：HD2IP
Add
Select
key to enter addition interface, and press
0 1 0 1 0 1 ：
： ：
主 页 主 页
key to confirm the addition operation. If this parameter is
key or key is pressed without selecting addition
16:02:35
Return
-40-
Basic Operation Instructions
16:02:35 Forward
Ensure to add to the parameter list
displayed in stop state?
Return Homepage
16:02:35
16:::02:35 Forward
H D 2 I P H D 2 I P H D 2 I P
Ensure to add to the parameter list
displayed in running state?
确认添加到运行状
行状态显示参数？ 态 显示参数？ 态 显示参数？
Return Homepage
Forward Local Ready 01：HD2IP
Ensure to add to common
parameter setup?
Homepage
key, key or
Local
Ready 01: HD2IP
Confirm
0 1 0 1 0 1 ：
： ：
01: HD2IP
Local Ready
确 认添加到运行状 确 认添加到运
C 确o定 定 nfirm
确
Confirm
key to