Table of Contents
Advertisement
HD2 IP55 High-ingress Protection Series Inverter
Image
or
D.3 Power supply
Refer to the electrical installation.
D.4 Cables
D.4.1 Power cables
The sizes of the input power cables and motor cables must meet the local regulation.
Name
Cable
Breaker
Input reactor
Input filter
Brake unit or brake
resistor
Output filter
Output reactor
Ensure that the voltage class of the inverter is consistent with that of the
grid.
Accessory for signal transmission
Device for electric shock prevention and
protection against short-to-ground that may
cause current leakage and fire. Select
residual-current circuit breakers (RCCBs)
that are applicable to inverters and can
restrict high-order harmonics, and of which
the rated sensitive current for one inverter is
larger than
30 mA.
Accessories used to improve the current
adjustment coefficient on the input side of the
inverter,
and
harmonic
currents.
Accessory that restricts the electromagnetic
interference generated by the inverter and
transmitted to the public grid through the
power cable. Try to install the input filter near
the input terminal side of the inverter.
Accessories
regenerative energy of the motor to reduce
the deceleration time.
inverters of HD2IP-75A-43 or lower only
need to be configured with brake resistors,
and inverters of above HD2IP-75A-43
support optional brake units.
Accessory used to restrict interference
generated in the wiring area on the output
side of the inverter. Try to install the output
filter near the output terminal side of the
inverter.
Accessory used to lengthen the valid
transmission distance of the inverter, which
effectively restrict the transient high voltage
generated during the switch-on and
switch-off of the IGBT module of the inverter.
-322
Description
thus
restrict
high-order
used
to
consume
the
Advertisement
Table of Contents
