State Monitoring Interface; Motor Parameter Autotuning - IMO HD2 IP Series Instruction Manual

HD2 IP55 High-ingress Protection Series Inverters
16:02:35
Forward Local Ready 01: HD2IP
P00.00: Speed control mode
P00.01: Running command channel
P00.02: Communication command channel
P00.03: Max. output frequency
P00.04: Upper limit of running frequency
P00.05: Lower limit of running frequency
Return Add
In parameter selection edit interface, the "authority" on the top right indicates whether this
parameter can be modified or not.
"√" indicates the set value of this parameter can be modified under current state.
"×" indicates the set value of this parameter cannot be modified under current state.
"Current value" indicates the value saved last time.
"Default value" indicates the default value of this parameter.

5.4.7 State monitoring interface

In the fourth-level menu of "state monitoring/fault record" menu, press
key to enter state monitoring interface. After entering state monitoring interface, the
current parameter value will be displayed in real time, this value is the actually detected value
which cannot be modified.
In state monitoring interface, press
16:02:35 Forward
P17.00：Set frequency
P17.01: Output frequency
P17.02: Ramps reference frequency
P17.03: Output voltage
P17.04: Output current
P17.05: Motor speed
Return

5.4.8 Motor parameter autotuning

In "Motor parameter autotuning" menu, press
parameter autotuning selection interface, however, before entering motor parameter autotuning
interface, users must set the motor nameplate parameters correctly. After entering the interface,
select motor autotuning type to carry out motor parameter autotuning. In motor parameter
autotuning interface, press
Figure 5-16 Parameter setup edit interface
Select
Figure 5-17 State monitoring interface
Local Ready 01: HD2IP
Add
Select
key or
key or key to return to the previous menu.
16:02:35 Forward
Setting frequency
Max. value: 630.00
Min. value: 0.0
Default value: 0.0
Return
key,
key to return to the previous menu.
-42-
Basic Operation Instructions
key,
Local Ready 01: HD2IP
Hz
50.00
Homepage
Confirm
key or key to enter motor
key or