Step 16. Install Steps; Step 17. Install Toolbox - MacDon M Series Assembly Instructions Manual

STEP 16. INSTALL STEPS

The following procedure is applicable
to the M150 and M200 machines with
LH and RH platforms. The M100 has
a LH platform only. RH installation is
shown, LH installation is opposite.
a. Install two ½ in.x1.0 hex bolts in upper holes in
platform. Do not thread in fully.
b. Remove step assemblies from shipping frame.
Retain hardware.
c. Hang step assembly on bolts.
assemblies are the same.
d. Install two ½ in.x1.0 lg. hex bolts in lower holes
in step and tighten.
e. Tighten upper bolts.
f. Repeat for other step assembly.
Form # 169242
UNLOADING AND ASSEMBLY

STEP 17. INSTALL TOOLBOX

a. Open maintenance platform on LH side.
b. Attach toolbox holder to brackets on the frame
Both step
c. Locate toolbox in holder.
d. Position hose bundle in hook on tool box holder.
36
with two 3/8 in.x0.75 lg. carriage bolts and nuts.
Note provision for grease gun holder.
Model Year - 2009