Step 8. Remove Wheel & Platform Support; Step 9. Assemble Windrower Tractor Support Stand - MacDon M Series Assembly Instructions Manual

STEP 8. REMOVE WHEEL &
PLATFORM SUPPORT
a. Remove cross brace, and the two upright
supports from frame.
b. Remove the cross member over the hood and
the two uprights on either side.
Form # 169242
UNLOADING AND ASSEMBLY
STEP 9. ASSEMBLE WINDROWER
a. Remove all shipping materials from stand.
b. Arrange forward and rear stands on level ground
c. Attach four support tubes to stands as shown
d. Set up air control valve tripod. Remove plug on
e. The stand is now operational. Instructions for
18
TRACTOR SUPPORT
STAND
Special stands for assembling the windrower
tractor are available from the factory.
stand is not available, an equivalent support
system can be used.
capable of holding a 20,000 lb (9072 kg) load.
Assemble factory stand as follows:
FORWARD STAND
so that attachment lugs on each stand face each
other.
with hardware provided and tighten.
valve and install a 100 psi (689 kPa) air line.
use are given in the appropriate sections.
WARNING
Use stand only as instructed in this manual.
Do not use stand for any other purpose.
Do not pressurize air bags beyond 120 psi
(827 kPa).
If this
The stand must be
SUPPORT
REAR STAND
Model Year - 2009