Hydraulic Oil Level; Fuel Separator - MacDon M Series Assembly Instructions Manual

b. Check spring clamp at back of air cleaner
(M150, M200).
TYPICAL CONNECTION
c. Check spring clamps on charge air cooling duct
connections (at turbocharger outlet, engine
intake and inside cooling box).
E. HYDRAULIC OIL LEVEL
a. Turn filler cap counterclockwise to loosen bung,
and remove dipstick.
Form # 169242
PRE-DELIVERY CHECKS
HOLD 0.018 in. (0.46 mm)
GAUGE BETWEEN MIDDLE
COILS & TIGHTEN CLAMP
UNTIL GAUGE IS SNUG
b. Check that level is between LOW and FULL
marks.
c. Reinstall filler cap and turn clockwise to tighten
bung.
F. FUEL SEPARATOR
a. Turn drain valve by hand 1½ to 2 turns
counterclockwise until draining occurs.
b. Drain the filter sump of water and sediment until
clear fuel is visible. Clean as necessary.
c. Turn the valve clockwise to close the drain.
77
M100 & M150
M200
Model Year - 2009