Step 14. Install Hydraulics - MacDon M Series Assembly Instructions Manual

STEP 14. INSTALL HYDRAULICS

A. M150, M200
a. The hydraulic hoses under the cab may require
proper placement under the existing clip.
necessary, proceed as follows:
1. Locate hose clip under the cab and remove
clip.
VIEW FORWARD
2. Position the two hoses 111323 (orange tie)
and 111324 with tee (white ties), (three if
M200) as shown under the center of the clip
and loosely install two bolts and nuts. Part
numbers are located on hoses.
3. Position remaining hoses under clip as
shown and tighten bolts.
Form # 169242
UNLOADING AND ASSEMBLY
If
111557 YELLOW
111323 BLUE
111323 ORANGE
111324 WHITE 'T'
111324 (M200 ONLY)
(NOT SHOWN)
111327 GREEN 'T'
111328 WHITE
27
b. Connect hoses as follows using coloured plastic
cable ties as a guide.
111327 GREEN
1. Locate two hoses 111327 (green ties) in
frame opening, and existing tee fitting (green
tie).
2. Remove caps on green lines and tee, and
make connections. Tighten fittings.
Remove caps on tee last to minimize
oil loss.
3. Position hoses into frame.
4. Locate two hoses (white ties) inside frame
and hose 111324 with tee (white tie).
5. Remove caps, make connections, and
tighten fittings.
6. Push hoses into frame.
NOTE
111324 WHITE 'T'
(continued next page)
Model Year - 2009