MacDon M Series Assembly Instructions Manual page 58

3. Install clevis pin (F) and secure with cotter
pin.
4. Adjust link to required length for proper
header angle by rotating barrel (E). Tighten
nut (D) against barrel. A slight tap with a
hammer is sufficient.
5. Proceed to step e.
HYDRAULIC LINK WITHOUT SELF-ALIGNMENT
KIT – M200 STD, M150 OPTION
1. Re-locate the pin at the frame linkage as
required to position the hook over the
header pin.
Form # 169242
UNLOADING AND ASSEMBLY
E
F
HEADER
TILT DOWN
2. Activate header tilt cylinder switches on GSL
to extend or retract center link cylinder so
that the hook lines up with the header
attachment pin.
H
3. Push down on rod end of link cylinder (G)
until hook engages pin (H) on header and is
locked.
4. Check that center link is locked onto header
by pulling upward on rod end of cylinder.
5. Proceed to step e.
56
HEADER UP
HEADER TILT UP
HEADER DOWN
G
(continued next page)
Model Year - 2009