MacDon M Series Assembly Instructions Manual page 51

f. Connect center link as follows:
MECHANICAL LINK – M100, M150
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
J
1. Loosen nut (G) and rotate barrel (H) to
adjust length so that link lines up with
header bracket.
2. Install pin (J) and secure with cotter pin.
3. Adjust link to required length for proper
header angle by rotating barrel (H). Tighten
nut (G) against barrel. A slight tap with a
hammer is sufficient.
4. Proceed to step g.
HYDRAULIC LINK WITHOUT SELF-ALIGNMENT
KIT – M200 STD, M150 OPTION
1. Re-locate the pin at the frame linkage as
required to position the hook over the
header pin.
Form # 169242
UNLOADING AND ASSEMBLY
G
H
HEADER
TILT DOWN
2. Activate header tilt cylinder switches on GSL
to extend or retract center link cylinder so
that the hook lines up with the header
attachment pin.
3. Push down on rod end of link cylinder (K) until
hook engages pin on header and is locked.
4. Check that center link is locked onto header
by pulling upward on rod end of cylinder.
5. Proceed to step g.
49
HEADER UP
HEADER TILT UP
HEADER DOWN
K
(continued next page)
Model Year - 2009