MacDon M Series Assembly Instructions Manual page 56

DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header.
g. Engage lift cylinder stops on both lift cylinders.
h. Install pin (A) through each boot and foot and
secure with hairpin.
IMPORTANT
Ensure pin (A) is fully inserted and
hairpin is installed behind bracket on
boot.
i. Remove lynch pin from pin (J) in stand (K).
j. Hold stand and remove pin (J).
k. Reposition stand to storage position by inverting
stand and re-locating on bracket as shown.
Reinsert pin (J) and secure with lynch pin.
Form # 169242
UNLOADING AND ASSEMBLY
A
K
J
l. Remove pin (L) from storage position in linkages
on both sides and insert in hole (M) to engage
float springs. Secure with lynch pin.
m. Disengage lift cylinder stops.
CAUTION
Check to be sure all bystanders have cleared
the area.
n. Start engine, and activate header lift cylinder
switch on GSL to lower header fully.
engine and remove key.
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
o. Connect header drive hydraulics and electrical
harness to header.
Refer to the Auger Header Operator's
Manual for instructions on attaching
the hydraulics and electrical to the
auger header.
54
L
M
NOTE
Model Year - 2009
Stop