MacDon M Series Assembly Instructions Manual page 31

c. Remove clamp from round plastic hose block.
TRACTION DRIVE - LH
CASE DRAIN
VIEW LOOKING AFT TOWARDS PUMPS
d. Insert four traction drive hoses and one case
drain hose into slots in block as shown and re-
install clamp.
Form # 169242
UNLOADING AND ASSEMBLY
TRACTION DRIVE - RH
e. Connect drive hoses to pump as follows:
SHORT – YELLOW
1. Remove caps and attach hoses with short
elbows to respective side of pump (either
yellow or no tie). Tighten fittings.
LONG – NO TIE
2. Remove caps and attach hoses with long
elbows to respective side of pump (either
red or no tie). Tighten fittings.
f. Retrieve the two motor case drain hoses
(111312) at front frame, and the 7/8 in. tee fitting
on the hose from the pump.
g. Remove caps from the hoses only.
29
SHORT – NO TIE
LONG - RED
(continued next page)
Model Year - 2009