Operational Checks; Engine Warning Lights; Start Engine; Gauges And Cdm Display - MacDon M Series Assembly Instructions Manual

K. OPERATIONAL CHECKS
I. ENGINE WARNING LIGHTS
a. Turn ignition key to RUN position.
b. Single loud tone sounds, and engine warning
lights illuminate.
II. START ENGINE
a. Check fuel level and if required add sufficient
fuel for a 15 minute run.
b. Start engine. Refer to STEP 20.
III. GAUGES AND CDM DISPLAY
M150, M200
a. Check engine temperature gauge and fuel
gauge are working.
b. Check CDM display is working by pushing
SELECT on CDM or SELECT button on GSL.
GROUND SPEED
mph or kph
ENGINE RPM

ENGINE WARNING LIGHTS

Engine Pre-Heat/Water In
Fuel/Do not Operate/Stop Engine
IGNITION SWITCH POSITIONS
Accessory/Stop/Run/Start
Form # 169242
PRE-DELIVERY CHECKS
DISPLAY
Engine/Tractor Functions
M150, M200 SHOWN – M100 SIMILAR
IV. ENGINE SPEED
a. Check engine rpm on CDM.
M100
M150
M200
HAZARD WARNING LIGHTS SWITCH
Activates Hazard Warning Flashers
Cancels Turn Signal
Allows Operator To Select Display Item
On Lower Line.
Push To Select
TURN SIGNAL SWITCHES
Activates Turn Signals On Tractor and Header
Engine Forward Mode Only
Push-On/Push-Off
80
IDLE MAX RPM (No Load)
1100 2630-2650
1100 2270-2330
1100 2250-2300
SELECT SWITCH
Model Year - 2009