Step 6. Install Light And Mirror Assemblies - MacDon M Series Assembly Instructions Manual

STEP 6. INSTALL LIGHT AND
MIRROR ASSEMBLIES
a. Remove two bolts
assemblies to shipping stand and remove
assemblies.
b. The cab roof must be raised to install the light
assemblies. Proceed as follows:
1. Remove plastic
locations in roof.
2. Remove nuts
locations.
Form # 169242
UNLOADING AND ASSEMBLY
securing mirror/light
covers from six
and washers at these
3. Lift roof and support with wooden block
covered with foam to prevent scuffing of
roof.
c. Move existing harness in roof to gain access to
mirror/light support clamps. Loosen U-bolt.
bolt
d. Install mirror/light into U-bolt and tighten nuts on
U-bolt so that support tube is securely fastened.
Tighten jam-nuts located under roof plate.
15
(continued next page)
Model Year - 2009