Step 3. Install Gauge Rollers Or Adjustable Shoes - 16 Ft Only - MacDon R80 Unloading And Assembly Instructions

STEP 3. INSTALL GAUGE
ROLLERS OR
ADJUSTABLE SHOES –
16 FT ONLY
If kits are not supplied, proceed to STEP 4,
LOWER MOWER CONDITIONER, otherwise
proceed as follows:
NOTE
These kits may be installed later in the
header assembly sequence but it may
be easier prior to laying the header
down.
I. GAUGE ROLLERS
a. Unpack gauge roller bundle.
b. Remove four clevis pins from roller assembly.
c. Position gauge roller assembly on frame and
secure with two clevis pins (A). Secure pins
with lynch pins.
Form # 169080
UNLOADING AND ASSEMBLY
A
d. Adjust roller assembly to desired height and install
two clevis pins (B). Secure with lynch pins.
e. Repeat above steps for opposite side. Set both
gauge rollers to same position.
II. SKID SHOES
a. Unpack skid shoe bundle.
b. Remove four clevis pins from skid shoe.
c. Position skid shoe on frame and secure with two
clevis pins (C). Secure pins with lynch pins.
d. Adjust skid shoe to desired height and install two
clevis pins (D). Secure with lynch pins.
e. Repeat above steps for opposite side. Set both
skid shoes to same position.
10
B
C
D
Model Year - 2010