Step 23. Install Am/Fm Radio - MacDon M Series Assembly Instructions Manual

STEP 23. INSTALL AM/FM RADIO

Provision has been made for installation of
AM/FM radio. The mounting is designed to fit a
DIN E style radio with a depth X=161 mm and
having a 5 mm threaded stud centered on the
rear for support. Provision has been made for
adjustments should the radio fall outside these
parameters.
M100 configuration is slightly different
but the installation procedure is the
same.
a. Ensure the ignition is turned to the OFF position.
b. Remove radio panel by removing four screws
(A).
C
c. Remove screw and nuts (B) and (C) to remove
support (D) from panel. Retain metric nut (C)
and lockwasher.
d. Remove the cut-out by cutting the tabs (E) in the
panel. Remove sharp edges on panel.
Form # 169242
UNLOADING AND ASSEMBLY
X
NOTE
A
D
B
E
F
e. Locate receptacle (F) (supplied with radio) in
opening and secure by bending tabs (G) on
receptacle against panel.
H
f. Insert radio into receptacle and attach radio
bezel. Ensure radio locks into position and
faceplate (H) is against the panel.
g. A six-pin connector for the radio is included in
the wiring harness. In order to mate properly
with this connector, the radio must have a six-
pin connector (Packard #2977042) and have a
terminal arrangement as follows:
h. Attach two additional wires in the wiring harness
to the radio:
1. Circuit 503, Red with 1/4 in. female blade
terminal. This is a live wire provided for
powering a radio clock/memory, if these
exist on your radio.
2. Circuit 315, Black ground wire attaches to
radio body.
i. Plug cable from antenna into radio.
An approved
available from Radio Engineering
Industries (REI) of Omaha, Nebraska.
45
G
NOTE
radio package is
(continued next page)
Model Year - 2009