Step 4. Install Reel Lift Cylinders - MacDon Harvest Header D65 Assembly Instructions Manual

STEP 4. INSTALL REEL LIFT
CYLINDERS
CAUTION
Braces On Reel Arms Keep Reel From Sliding
Forward. Do Not Remove.
a. Remove two top bolts on outboard reel arm
support—both ends.
DOUBLE REEL ONLY
b. Remove two top bolts on center reel arm support
(DOUBLE REEL ONLY).
169603
UNLOADING AND ASSEMBLY
c. Position sling around the reel tube close to
d. Remove shipping wire/banding from cylinder, and
e. Lift reel so that reel lift cylinder mounting holes line
f.
15
outboard end of reel, and attach sling to a forklift
(or equivalent).
remove pins from lug and arm.
up with lug on endsheet and hole in reel arm.
RH SHOWN - LH OPPOSITE
Secure cylinder to endsheet and reel arm with
pins as shown. Note orientation of pins. Secure
with cotter pins.
NOTE
Cotter pin outboard
cotter pin inboard at endsheet.
at reel arm;
(continued next page)
Revision B