Step 25. Attach Header; Header Attachment - D Series - MacDon M Series Assembly Instructions Manual

STEP 25. ATTACH HEADER

A. HEADER ATTACHMENT - D SERIES
a. If not installed, attach draper header boots
(supplied with header) to tractor lift linkage as
follows:
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
B
1. Remove pin (A) from boot (B).
C
B
2. Locate boot (B) on lift linkage (C) and
reinstall pin (A). Pin may be installed from
either side of boot.
3. Secure pin (A) with hairpin.
4. Repeat for opposite side.
Form # 169242
UNLOADING AND ASSEMBLY
b. Remove hairpin on pins (D) and remove pins
A
c. Start the engine and activate header down
A
d. Slowly drive tractor forward so that boots (B)
e. Check that linkages are properly engaged in
48
D
from header legs.
CAUTION
Check to be sure all bystanders have cleared
the area.
HEADER UP
HEADER
TILT DOWN
HEADER DOWN
button on the GSL to fully retract header lift
cylinders.
E
enter header legs (E). Continue to drive slowly
forward until linkages contact support plates in
the lower header legs, and header nudges
forward.
header legs, contacting support plates.
HEADER TILT UP
B
(continued next page)
Model Year - 2009