MacDon M Series Assembly Instructions Manual page 34

YELLOW
13. Remove the cap from fitting with yellow tie
on the valve block from inboard side of
frame.
14. Loosen bolts and move valve block to
improve access through hole in frame for
wrenches when tightening fittings.
15. Retrieve matching
connection on valve block. Tighten fitting.
16. Reposition valve block and re-tighten bolts.
b. Connect drive hoses to pump as follows:
1. Remove caps and attach hoses (green and
yellow ties) to matching fittings on top of
pump. Tighten fittings.
Form # 169242
UNLOADING AND ASSEMBLY
hose and make
2. Remove caps and attach hoses (red and
white ties) to matching fittings on bottom of
pump. Tighten fittings.
c. Retrieve the two motor case drain hoses
(111312) at front frame, and the 7/8 in. tee fitting
on the hose from the pump.
d. Remove caps from the hoses only.
e. Remove one cap on tee fitting and quickly attach
hose to minimize oil spillage.
f. Remove second cap from tee and quickly
connect other hose.
g. Tighten fittings.
32
(continued next page)
Model Year - 2009