Forklift Method - MacDon M Series Assembly Instructions Manual

b. Attach lifting frame assembly (MacDon Part #
163871) to the four designated lift points on
windrower tractor shipping frame.
c. Lift windrower tractor off platform and move to
setup area.
d. Lower assembly onto 5-6 inch (127-152 mm)
blocks as shown.
e. Remove chains from shipping frame.
f. Check for shipping damage and missing parts.
Form # 169242
UNLOADING AND ASSEMBLY
9
B. FORKLIFT METHOD
CAUTION
To avoid injury to bystanders from being
struck by machinery, do not allow persons to
stand in unloading area.
CAUTION
Equipment used for unloading must meet or
exceed the requirements specified below.
Using inadequate equipment may result in
chain breakage, vehicle tipping or machine
damage.
LIFTING VEHICLE
Min. Lifting Capacity *
* At 48 inches (1220 mm) from back end of
forks.
IMPORTANT
Forklifts are normally rated for a load
located 24 inches (610 mm) ahead of
back end of the forks. To obtain the
forklift capacity at 48 inches (1220
mm), check
distributor.
WARNING
Be sure forks are secure before moving away
from load. Stand clear when lifting.
a. Approach windrower tractor from the hood end,
and slide forks underneath lifting framework.
b. Raise windrower tractor off platform and move to
assembly area.
20,000 lb (9072 kg)
with your forklift
(continued next page)
Model Year - 2009