Step 6. Install Steps; Step 7. Install Center-Link - MacDon M105 Assembly Instructions Manual

STEP 6. INSTALL STEPS

a. Remove two bolts securing steps to platform,
and remove steps.
b. Remove the one existing upper bolt.
c. Re-install one bolt in lower hole in platform. Do
not thread in fully.
d. Hang step assembly on bolts. Back off bolts if
required.
e. Install two remaining bolts in upper holes in step,
and tighten.
f. Tighten upper bolts installed in step a.
Form 169558
UNLOADING AND ASSEMBLY
17

STEP 7. INSTALL CENTER-LINK

MECHANICAL LINK
a. Remove clevis pin from center-link.
b. Position link between mounting brackets on front
frame, and attach at lower hole location.
c. Install clevis pin, and secure with hair pin.
HYDRAULIC LINK - OPTIONAL
The hydraulic center-link is supplied in a
separate kit that is included with the shipment.
Refer to installation instructions in the kit.
Revision A