Setting The Pulse Range, Pulse Count, And Pulse Rating - YOKOGAWA WT3002E User Manual

1.6 Setting the Pulse Range, Pulse Count, and
Pulse Rating
Procedure
1-12
RESET SET
Cursor keys
PAGE PAGE
SCALING LINE FILTER AVG
MOTOR FREQ
SET FILTER
HRM SET MEASURE SYNC SOURCE
CURSOR NULL
FILE IMAGE SAVE STORE
MENU STORE SET
PRINT MISC HELP
MENU
The settings covered in this section apply to the case when the input signal type is set to
Analog. You do not have to specify the settings in this section if the input signal type is
set to Pulse.
1.
Press SHIFT+SCALING (MOTOR SET) to display the Motor Set dialog box.
• Setting the Pulse Input Range of the Revolution Signal
If the revolution signal type is Pulse, set the upper and lower limits of the pulse input
range.
2.
Press the cursor keys to select Pulse Range Upper under Speed.
3.
Press SET. A pulse input range setup box appears.
4.
Press the cursor keys to set the upper limit of the pulse input range.
5.
Press SET or ESC to close the box.
6.
Press the cursor keys to select Pulse Range Lower under Speed.
7.
Press SET. A pulse input range setup box appears.
8.
Press the cursor keys to set the lower limit of the pulse input range.
9.
Press SET or ESC to close the box.
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER
LOWER ITEM LOWER FORM USER SET
To exit the menu during operation, press ESC located above the
soft keys.
In the procedural explanation below, the phrase "press the cursor
keys" may be used. This phrase refers to the procedures for
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User's Manual,
IM WT3001E-01EN.
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
IM WT3001E-51EN
REMOTE
LOCAL
SHIFT