Selecting The Analog Range - YOKOGAWA WT3002E User Manual

1.4

Selecting the Analog Range

Procedure
IM WT3001E-51EN
RESET SET
Cursor keys
PAGE PAGE
To exit the menu during operation, press ESC located above the
SCALING LINE FILTER AVG
soft keys.
MOTOR FREQ
SET FILTER
In the procedural explanation below, the phrase "press the cursor
HRM SET MEASURE SYNC SOURCE
keys" may be used. This phrase refers to the procedures for
CURSOR NULL
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User's Manual,
FILE IMAGE SAVE STORE
IM WT3001E-01EN.
MENU STORE SET
PRINT MISC HELP
MENU
The settings covered in this section apply to the case when the input signal type is set to
Analog. You do not have to specify the settings in this section if the input signal type is
set to Pulse.
1.
Press SHIFT+SCALING (MOTOR SET) to display the Motor Set dialog box.
• Selecting the Analog Input Range of the Revolution Signal
• Selecting Auto Range
2.
Press the cursor keys to select Auto Range under Speed.
3.
Press SET. An auto range selection box appears.
4.
Press the cursor keys to select ON or OFF.
5.
Press SET to confirm the auto range setting.
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER ELEMENT
LOWER ITEM LOWER FORM USER SET ALL
REMOTE
UPDATE
HOLD LOCAL
RATE
SINGLE
CAL
INTEG SHIFT
START STOP
1-7
1
2
3
4
5
6
7
8
9
10
11
12
13
Index