Displaying The Power Spectrum On The Split Screen - YOKOGAWA WT3002E User Manual

11.8 Displaying the Power Spectrum on the Split
Screen
Procedure
VOLTAGE RANGE
ELEMENT
2
1
3 4
ELEMENT
ALL
COMPEN
MEASURING
RMS MEAN
WIRING
INPUT INFO.
RESET SET
Cursor keys
PAGE PAGE
Explanation
11-16
MODE AUTO
DC RMEAN
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER
LOWER ITEM LOWER FORM USER SET
1.
Press FORM to display the FFT Form menu.
If the FFT display is at the lower section of the screen on the split display, press
SHIFT+FORM (LOWER FORM).
2.
Press the Format soft key to display the FFT Format menu.
3.
Press one of the keys from Single or Dual to select the number of windows.
The screen can be evenly divided and the waveforms can be assigned to the divided
windows. Select the number of divisions of the screen from the choices below.
• Single: 1 window
• Dual: 2 equally divided windows
The number of displayed points in the vertical direction of one divided window varies
depending on the number of divisions as follows:
• Single: 432 points
• Dual: 216 points
CURRENT RANGE
MEASURING
MODE
RMS MEAN DC RMEAN
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
To exit the menu during
EXT SENSOR
operation, press ESC located
SENSOR RATIO
above the soft keys.
In the procedural explanation
below, the phrase "press the
cursor keys" may be used.
This phrase refers to the
AUTO
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the User's
REMOTE
Manual, IM WT3001E-01EN.
LOCAL
SHIFT
IM WT3001E-51EN