Table of Contents
Advertisement
Setting Conditions and Making Measurements
Logging in as a User
Setting the Measurement Range
DX100P
DX100P
IM 04L05A01-02E
This section describes the procedure for setting the measurement conditions, making
measurements, and applying electronic signature to the saved measurement data.
Of the measurement conditions, the procedure for setting the measurement range, batch
conditions, and messages to be written to the measured data are explained. For the
procedure for setting other items, see chapter 5 in IM04L05A01-01E (DX100P) or
IM04L06A01-01E (DX200P).
The procedure is the same as for "Logging in as an Administrator" on page 20.
1.
Press MENU.
The engineering mode menu appears.
2.
Press the
#1 soft
The Range, Alarm screen is displayed.
3.
Set each item.
First-CH, Last-CH
Channels to be set up
Mode: Input type
Range: Input range
Span Lower, Span Upper
Lower and upper limits of the
display span
4.
Press
DISP/ENTER
The settings are confirmed.
5.
Press
ESC
to return to the engineering mode menu.
key.
DX200P
DX200P
each time the specified channels are set.
27
Advertisement
Table of Contents
