Table of Contents
Advertisement
Explanation
IM WT3001E-51EN
When auto print is used, screen images and numeric data lists can be printed
automatically on the built-in printer at the specified print interval.
• Limitations on the Auto Print Function by Measurement Modes
There are limitations on the setting and execution of auto print in measurement modes
other than normal measurement mode.
• The synchronization mode (Synchronize) cannot be set to integration
synchronization mode (Integrate), because the integration function is not available
in the following measurement modes.
• Wide bandwidth harmonic measurement mode
• Waveform computation mode
• FFT mode
• The auto print function cannot be used in the following measurement modes.
• IEC harmonic measurement mode
• Voltage fluctuation and flicker measurement mode
• Cycle-by-cycle measurement mode
• Setting the Print Destination, Output Format, Etc.
To use the auto print function, you must set the print destination to the built-in printer
and set the output format (screen image/numeric data) and other settings. For the
Procedure, see section 2.3 or 2.4.
Note
•
If numerous measurement functions are set as print items, printing may take a long time.
Set the print interval longer than the time needed for printing.
•
If you operate the keys or perform communications at the time of printing, the print start time
may be delayed, or the printing may take a long time.
• Selecting the Synchronization Mode of the Auto Print
You can select the method used to start/stop the auto print from the following:
• Timer:
Starts/Stops printing in sync with preset reservation times (start and stop
times) (print timer synchronized auto print).
• Integrate: Starts/Stops printing in sync with integration start/stop (integration
synchronized auto print).
• Setting the Reservation Time
Set the time to start/stop the auto print in year:month:day, hour:minute:second.
The start and stop times can be specified only when the synchronization mode is
set to Timer. Make sure the reservation time for stopping the auto print is after the
reservation time for starting the auto print.
The selectable range of the values is as follows:
• Year: 4-digit year
• Hour:Minute:Second: 00:00:00 to 23:59:59
Note
•
The reservation time allows up to 31 days to be specified for February. If an invalid time is
specified, an error message is displayed at the time of execution of the auto print. Reset the
reservation time in this case.
•
Leap years are recognized at the time of execution of the auto print.
2.5 Auto Print
1
2
3
4
5
6
7
8
9
10
11
12
13
Index
2-15
Advertisement
Table of Contents
