Displaying The Bar Graph And Making Cursor Measurements - YOKOGAWA WT3002E User Manual

7.9 Displaying the Bar Graph and Making Cursor
Measurements
Procedure
VOLTAGE RANGE
ELEMENT
1 2
3 4
ELEMENT
ALL
COMPEN
MEASURING
RMS MEAN
WIRING
INPUT INFO.
RESET SET
Cursor keys
PAGE PAGE
SCALING LINE FILTER AVG
MOTOR FREQ
SET FILTER
HRM SET MEASURE SYNC SOURCE
CURSOR NULL
7-30
MODE AUTO
DC RMEAN
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER
LOWER ITEM LOWER FORM USER SET
• Displaying Bar Graphs
1.
Press OTHERS to display the Others menu.
2.
Press any of the soft keys from Bar, Numeric+Bar, Wave+Bar, and Bar+Trend
to select the display mode.
Press the
Next 1/2
soft key
The following procedures are given as typical examples in which the
display mode is set to Bar.
• Selecting the Item to Be Changed
3.
Press ITEM to display the Bar Item menu.
If the bar graph is at the lower section of the screen on the split display, press
SHIFT+ITEM (LOWER ITEM).
4.
Press the cursor keys to select a value between 1 and 3.
• Changing the Measurement Function
5.
Press the Function soft key to display the measurement function selection box.
6.
Press the cursor keys to select the measurement function.
7.
Press SET. The symbol for the selected measurement function and the bar graph
are displayed.
CURRENT RANGE
MEASURING
MODE
RMS MEAN DC RMEAN
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
To exit the menu during
EXT SENSOR
operation, press ESC located
SENSOR RATIO
above the soft keys.
In the procedural explanation
below, the phrase "press the
cursor keys" may be used.
This phrase refers to the
AUTO
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the User's
REMOTE
Manual, IM WT3001E-01EN.
LOCAL
SHIFT
IM WT3001E-51EN