Executing The Normal Voltage Fluctuation And Flicker Measurement - YOKOGAWA WT3002E User Manual

12.5 Executing the Normal Voltage Fluctuation and
Flicker Measurement
Procedure
VOLTAGE RANGE
ELEMENT
2
1
3 4
ELEMENT
ALL
COMPEN
MEASURING
RMS MEAN
WIRING
INPUT INFO.
RESET SET
Cursor keys
PAGE PAGE
12-18
MODE AUTO
DC RMEAN
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER
LOWER ITEM LOWER FORM USER SET
Check that the flicker measurement status is indicating Reset. If not, set the flicker
measurement status to Reset according to the procedure in "Resetting the Voltage
Fluctuation and Flicker Measurement" on page 12-21.
1.
Set the measurement method to flicker according to the procedure given in "Setting
the Measurement Conditions" in section 12.3.
2.
Set the measurement range, input filter, scaling, etc. (see chapter 4 in the User's
Manual IM WT3001E-01EN).
3.
Apply the voltage of the power supply to be measured to this instrument.
• Initializing the Voltage Fluctuation and Flicker Measurement
4.
Press FORM to display the Flicker Form menu.
5.
Press the Initialize Exec soft key to start the initialization. The flicker
measurement status at the upper right section of the screen indicates Initializing.
When the initialization is complete, the flicker measurement status changes to
Ready.
CURRENT RANGE
MEASURING
MODE
RMS MEAN DC RMEAN
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
To exit the menu during
EXT SENSOR
operation, press ESC located
SENSOR RATIO
above the soft keys.
In the procedural explanation
below, the phrase "press the
cursor keys" may be used.
This phrase refers to the
AUTO
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the User's
REMOTE
Manual, IM WT3001E-01EN.
LOCAL
SHIFT
IM WT3001E-51EN