Selecting The Measured Source - YOKOGAWA WT3002E User Manual

9.4

Selecting the Measured Source

Procedure
Explanation
IM WT3001E-51EN
RESET SET
Cursor keys
PAGE PAGE
SCALING LINE FILTER AVG
MOTOR FREQ
SET FILTER
HRM SET MEASURE SYNC SOURCE
CURSOR NULL
FILE IMAGE SAVE STORE
MENU STORE SET
PRINT MISC HELP
MENU
1.
Press HRM SET to display the IEC Harmonics menu.
2.
Press the Object soft key to display the element/wiring unit selection box.
3.
Press the cursor keys to select any of the elements/wiring units starting with
Element1.
4.
Press SET. The symbol for the selected element number or wiring unit and the
numeric data are displayed at the highlighted position.
• Selecting the Measured Source
• You can select the measured source from the following elements/wiring units. The
selectable items vary depending on the installed elements.
Element1, Element2, Element3, Element4, ΣA, and ΣB
• If there are no elements that are assigned to the selected wiring unit, there is
no numeric data. Thus, [-------] (no data) is displayed in this case. For example,
if elements are assigned to ΣA and no elements are assigned to ΣB, then the
measurement function for ΣB shows [-------] (no data).
DISPLAY ITEM & ELEMENT
U / I / P
NUMERIC WAVE
WP/q/
OTHERS
TIME
ITEM FORM USER ELEMENT
LOWER ITEM LOWER FORM USER SET ALL
To exit the menu during operation, press ESC located above the
soft keys.
In the procedural explanation below, the phrase "press the cursor
keys" may be used. This phrase refers to the procedures for
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User's Manual,
IM WT3001E-01EN.
REMOTE
UPDATE
HOLD LOCAL
RATE
SINGLE
CAL
INTEG SHIFT
START STOP
Index
9-7
1
2
3
4
5
6
7
8
9
10
11
12
13