Setting The Measurement Conditions - YOKOGAWA WT3002E User Manual

13.3 Setting the Measurement Conditions

Procedure
VOLTAGE RANGE
ELEMENT
1 2
3 4
ELEMENT
ALL
COMPEN
MEASURING
RMS MEAN
WIRING
INPUT INFO.
RESET SET
Cursor keys
PAGE PAGE
13-6
MODE AUTO
DC RMEAN
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
FORM USER
ITEM
LOWER ITEM LOWER FORM USER SET
Check that the cycle-by-cycle measurement status is indicating Reset. If not, set
the cycle-by-cycle measurement status to Reset according to the procedure in
"Resetting the Cycle-by-Cycle Measurement" on page 13-16.
1.
Press FORM to display the CBC Form menu.
• Setting the Synchronization Source
2.
Press the Sync Source soft key to display the synchronization source selection
box.
3.
Press the cursor keys to select any of the elements/wiring units starting with U1.
4.
Press SET to confirm the new synchronization source.
CURRENT RANGE
MEASURING
MODE
RMS MEAN DC RMEAN
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
To exit the menu during
EXT SENSOR
operation, press ESC located
SENSOR RATIO
above the soft keys.
In the procedural explanation
below, the phrase "press the
cursor keys" may be used.
This phrase refers to the
AUTO
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
REMOTE see section 3.14 in the User's
Manual, IM WT3001E-01EN.
LOCAL
SHIFT
IM WT3001E-51EN