Table of Contents
Advertisement
Explanation
IM WT3001E-51EN
• Printing or Not Printing (ON/OFF) the Header Information
10.
Press the Information soft key to select ON or OFF.
• Executing the Print Operation
11.
Press PRINT to print the numeric data list.
• Aborting the Print Operation
12.
Press PRINT while the print operation is in progress to abort the operation.
• Header Information
The following items are available as header information.
• Measurement mode (Normal)
*1
• Date/Time
• Measurement range of each element
• PLL source
*2
Turning ON/OFF Header Information Printing
• ON: Prints the header information.
• OFF: Does not print the header information.
*1 Even if Information is set to OFF, the measurement mode and date/time are
always printed.
*2 Only installed elements are applicable for the selection.
• Selecting the Numeric Data
• Only installed elements and wiring units are applicable for the selection.
• There are limitations on the numeric data that can be measured and printed in
*3
measurement modes
numeric data limitations, see appendix 11 in the User's Manual IM WT3001E-01EN.
[-------] (no data) is printed in places where there is no numeric data.
• The harmonic order range is DC (0
*3 Can be set on models with the advanced computation (/G6) option. Wide
bandwidth harmonic measurement mode, IEC harmonic measurement mode,
waveform computation mode, and FFT mode are available.
• Print Format of the Numeric Data List
• The selected numeric data items are printed.
• For harmonic order data, the elements and measurement functions are printed
horizontally, and the order list is printed vertically.
2.4 Printing Numeric Data Lists on the Built-in Printer
*1
*2
other than normal measurement mode. For details on the
th
) to the Max Order specified in section 7.5.
1
2
3
4
5
6
7
8
9
10
11
12
13
Index
2-11
Advertisement
Table of Contents
