Setting The Delta Computation - YOKOGAWA WT3002E User Manual

6.2

Setting the Delta Computation

Procedure
VOLTAGE RANGE
ELEMENT
2
1
3 4
ELEMENT
ALL
COMPEN
MEASURING
RMS MEAN
WIRING
INPUT INFO.
RESET SET
Cursor keys
PAGE PAGE
6-2
MODE AUTO
DC RMEAN
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER
LOWER ITEM LOWER FORM USER SET
1.
Press WIRING to display the Wiring menu.
2.
Press the ∆Measure soft key to display the ∆Measure dialog box.
• Selecting the Target Wiring Unit for the Delta Computation
3.
Press the cursor keys to select the wiring unit.
(This step may not be necessary depending on the wiring system.)
4.
Press SET to confirm. A type selection box appears.
• Selecting the Delta Computation Type
5.
Press the cursor keys to select the delta computation type.
(The menu varies depending on the wiring system.)
6.
Press SET to confirm.
CURRENT RANGE
MEASURING
MODE
RMS MEAN DC RMEAN
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
To exit the menu during
EXT SENSOR
operation, press ESC located
SENSOR RATIO
above the soft keys.
In the procedural explanation
below, the phrase "press the
cursor keys" may be used.
This phrase refers to the
AUTO
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the User's
REMOTE
Manual, IM WT3001E-01EN.
LOCAL
SHIFT
IM WT3001E-51EN