Selecting The Iec Harmonic Measurement Mode - YOKOGAWA WT3002E User Manual

9.3

Selecting the IEC Harmonic Measurement Mode

Procedure
VOLTAGE RANGE
ELEMENT
1 2
3 4
ELEMENT
ALL
COMPEN
MEASURING
RMS MEAN
WIRING
INPUT INFO.
RESET SET
Cursor keys
PAGE PAGE
Explanation
9-6
MODE AUTO
DC RMEAN
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER
LOWER ITEM LOWER FORM USER SET
• Enabling IEC Harmonic Measurement Mode
1.
Press OTHERS to display the Others menu.
2.
Press the IEC Harmonics soft key.
Pres the Next1/3
soft key
If you use the Harmonic/Flicker Measurement Software, this instrument automatically
switches to IEC harmonic measurement mode.
This instrument cannot switch to IEC harmonic measurement mode in the following
conditions.
• When the master/slave synchronization measurement is set to slave.
• When the integration is started or stopped.
• When auto print is ON.
• While storage or recall operation is in progress.
• While the storage medium is being accessed.
• While saving waveform sampling data to the storage medium.
CURRENT RANGE
MEASURING
MODE
RMS MEAN DC RMEAN
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
To exit the menu during
EXT SENSOR
operation, press ESC located
SENSOR RATIO
above the soft keys.
In the procedural explanation
below, the phrase "press the
cursor keys" may be used.
This phrase refers to the
AUTO
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the User's
REMOTE
Manual, IM WT3001E-01EN.
LOCAL
SHIFT
IM WT3001E-51EN