Selecting The Power Spectrum To Be Displayed, Selecting The Fft Source, And Setting The Label - YOKOGAWA WT3002E User Manual

11.4 Selecting the Power Spectrum to Be Displayed,
Selecting the FFT Source, and Setting the Label
Procedure
VOLTAGE RANGE
ELEMENT
1 2
3 4
ELEMENT
ALL
COMPEN
MEASURING
RMS MEAN DC
WIRING
INPUT INFO.
RESET SET
Cursor keys
PAGE PAGE
IM WT3001E-51EN
MODE AUTO
RMEAN RMS
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER ELEMENT
LOWER ITEM LOWER FORM USER SET
1.
Press ITEM to display the FFT Items menu.
If the FFT display is at the lower section of the screen on the split display, press
SHIFT+ITEM (LOWER ITEM).
• Selecting the Power Spectrum to Be Displayed
2.
Press the FFT1 Display or FFT2 Display soft key to select ON or OFF.
CURRENT RANGE EXT SENSOR
SENSOR RATIO
MEASURING
AUTO
MODE
MEAN DC RMEAN
REMOTE
UPDATE
HOLD
LOCAL
RATE
SINGLE
CAL
INTEG SHIFT
START STOP
ALL
To exit the menu during
operation, press ESC located
above the soft keys.
In the procedural explanation
below, the phrase "press the
cursor keys" may be used.
This phrase refers to the
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the User's
Manual, IM WT3001E-01EN.
11-7
1
2
3
4
5
6
7
8
9
10
11
12
13
Index