Table of Contents
Advertisement
13.4 Executing the Cycle-by-Cycle Measurement
13-14
• Aborting the Cycle-by-Cycle Measurement
4.
Press the Reset soft key. An Alert dialog box appears.
5.
Press the cursor keys to select OK.
6.
Press SET. The cycle-by-cycle measurement is aborted. All the measured data
up to that point are discarded. The cycle-by-cycle measurement status indicates
Reset. To continue the cycle-by-cycle measurement, select Cancel in step 5 and
press SET.
• Aborting the Cycle-by-Cycle Measurement Automatically
7.
If the measurement is not completed within the timeout value, a timeout occurs,
and the measurement is aborted. The cycle-by-cycle measurement status
indicates Time Out. The Measure data is not displayed.
• Completing the Cycle-by-Cycle Measurement
8.
The cycle-by-cycle measurement stops automatically, when the measurement of
the specified measurement cycle is completed. The cycle-by-cycle measurement
status indicates Complete, and the measured data is displayed.
If the frequency of the synchronization source exceeds the frequency range (see
section 13.5), the cycle-by-cycle measurement status indicates Freq Err. The
measured data of frequencies outside the range is indicated as Error.
There are four ways to change the displayed items of measured data
list number 1 to 5. For the procedures of each method, see the pages
indicated below.
• Changing the displayed items using the function select key (see below)
• Selecting the displayed items from the menu (see page 13-15)
• Changing the Displayed Items Using the Function Select Key
The display of the measurement functions of U, I, P, S, Q, λ, Freq and the element/
wiring unit can be changed using function select keys.
• Selecting the Item to Be Changed
9.
Press ESC to clear the soft key menu at the right of the screen.
10.
Press the cursor keys to select the item to be changed. The item to be changed
is highlighted.
IM WT3001E-51EN
Advertisement
Table of Contents
