Setting The Anti-Aliasing Filter - YOKOGAWA WT3002E User Manual

7.8

Setting the Anti-Aliasing Filter

Procedure
7-28
RESET SET
Cursor keys
PAGE PAGE
SCALING LINE FILTER AVG
MOTOR FREQ
SET FILTER
HRM SET MEASURE SYNC SOURCE
CURSOR NULL
FILE IMAGE SAVE STORE
MENU STORE SET
PRINT MISC HELP
MENU
When making harmonic measurements, the line filter of normal measurement mode is
used as an anti-aliasing filter.
• Selecting the Line Filter
1.
Press LINE FILTER to display the Line Filter menu.
Only the installed elements are displayed.
• Selecting the Target Element
2.
Press one of the soft keys corresponding to the displayed element to select the
target element.
• Selecting the Line Filter
3.
Press the cursor keys to select any filter between OFF and 50 kHz. If any of
the target elements is set to a setting other than OFF, the LINE FILTER key
illuminates.
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
ITEM FORM USER
LOWER ITEM LOWER FORM USER SET
To exit the menu during operation, press ESC located above the
soft keys.
In the procedural explanation below, the phrase "press the cursor
keys" may be used. This phrase refers to the procedures for
selecting items and entering values and character strings. For
details on the procedures, see section 3.14 in the User's Manual,
IM WT3001E-01EN.
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
IM WT3001E-51EN
REMOTE
LOCAL
SHIFT