(Signal Amplitude) - YOKOGAWA WT3002E User Manual

11.6 Setting the Display Range of the X-Axis
(Frequency) and the Scale Type of the Y-Axis

(Signal Amplitude)

Procedure
VOLTAGE RANGE
ELEMENT
1 2
3 4
ELEMENT
ALL
COMPEN
MEASURING
RMS MEAN
WIRING
INPUT INFO.
RESET SET
Cursor keys
PAGE PAGE
11-12
MODE AUTO
DC RMEAN
DISPLAY ITEM & ELEMENT
NUMERIC WAVE U / I / P
WP/q/
OTHERS
TIME
FORM USER
ITEM
LOWER ITEM LOWER FORM USER SET
1.
Press FORM to display the FFT Form menu.
If the FFT display is at the lower section of the screen on the split display, press
SHIFT+FORM (LOWER FORM).
• Setting the Display Range of the X-Axis (Frequency)
2.
Press the Disp Start/Disp End soft key to select Disp Start, Disp end, or both
Disp Start and Disp End.
• If you select Disp Start, you can set the left end of the power spectrum display (minimum
value of the computed points).
• If you select Disp End, you can set the right end of the power spectrum display (maximum
value of the computed points).
• If you select both Disp Start and Disp End, you can set the computed points of the power
spectrum display without changing the offset between the computed points of Disp Start
and Disp End. The cursor is displayed at Disp Start.
3.
Press the cursor keys to set the computed point.
CURRENT RANGE
MEASURING
MODE
RMS MEAN DC RMEAN
UPDATE
HOLD
RATE
SINGLE
CAL
ELEMENT INTEG
START STOP
ALL
To exit the menu during
EXT SENSOR
operation, press ESC located
SENSOR RATIO
above the soft keys.
In the procedural explanation
below, the phrase "press the
cursor keys" may be used.
This phrase refers to the
AUTO
procedures for selecting
items and entering values
and character strings. For
details on the procedures,
see section 3.14 in the User's
REMOTE
Manual, IM WT3001E-01EN.
LOCAL
SHIFT
IM WT3001E-51EN